Announcement

Collapse
No announcement yet.

Bandsaw build

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • nick
    started a topic Bandsaw build

    Bandsaw build

    The plan


  • nick
    replied
    Just an update...
    working na pala tong bandsaw ko pero wala pa syang cover sa wheels





    my first project on the my bandsaw

    Leave a comment:


  • nick
    replied
    Wheels with tire....


    with angle bar support


    inalis ko muna yung isang v pulley papapalitan ko masyadong maluwag sa shafting.


    Leave a comment:


  • nick
    replied
    initial mounting ng wheels


    initial testing with motor




    after initial testing... found that the upper part of the bandsaw is vibrating around 3mm... so I placed a 1.5 x1.5 inch angle bars for support.

    Leave a comment:


  • nick
    replied
    @ Armand
    medyo malambot pa nga ang 2 inches thick na MDF... kaya ginawa ko nilagyan ko ng 1.5 x 1.5 inch na angle bar support sa likod... pagkalagay ko ng angle bars tigas na nya.

    Leave a comment:


  • Armand
    replied
    Nick, ngayon ko lang nakita to, I hope the 2 inches MDF body can hold the tension...delikado bro. Before proceeding take time to test it by sitting on top of the body then check kung nag bow by measuring the height before and after sitting on it. This was the advise to me by Matthias Wandel but my massive 4 1/2" bandsaw body was strong enough to resist bowing during the test and when tensioned. Baka mag crack ang gilid, try to find a way to re-inforce it with square bars masyado malutong ang MDF, delikado Nick.

    Leave a comment:


  • nick
    replied
    test fit of motor mounting... i will be using a water pump motor... but the problem is it is turning in the wrong direction. so i will be mouting it on the left side instead of the normal right side.

    Leave a comment:


  • nick
    replied
    half of the hole routed on the MDF


    clamp clamp clamps... 4 pieces 1/2inch MDF

    Leave a comment:


  • nick
    replied
    update...
    rough cut on the 1/2 inch MDF


    routed for final shape of mdf


    routed 1/2 holes for the mounting of wheels

    Leave a comment:


  • nick
    replied
    bandsaw specs will be... 14 inch capacity

    any inputs in the build will be highly appreciated... specially those who has an orginal bandsaws at their shop.

    Leave a comment:


  • nick
    replied
    cut out 4pieces 1/2 inch mdf for the body of the bandsaw.. it will glued all together.

    Leave a comment:


  • nick
    replied
    finished wheels


    use a router to create the grove on the center then spray with sanding sealer.

    Leave a comment:


  • nick
    replied
    cut out the wheels using Maktec router trimmer MT370 form MDF


    Leave a comment:


  • nick
    replied
    wheels


    bearing attachment


    wheels with bearing


    Leave a comment:

Related Articles

Collapse


Collapse
  • Filter
  • Time
  • Show
  • New Topics
Clear All
new posts
No content found
Show More
  • Filter
  • Time
  • Show
  • New Topics
Clear All
new posts
Please log in to your account to view your subscribed posts.

Related Articles

Collapse

Working...
X