This is probably one of the easiest jigs to build and churns out very good results
Picked the sled material and size. I chose this large 1/2" phenolic ply coz its pretty rigid and my runners will not be flushed to the table. Plus its huge because i need to make a circle that is 150cm in diameter. Hence i need to be able to pic the stock at 75 cm (radius)
Measuring for the runners
TS setup
Nice tight fit!
Re: circle cutting jig for table saw
Next runner
Aint so tight but good enough
trim excess off the sled
Nailing trial stock
Re: circle cutting jig for table saw
I got two circles where i dont know what to do with them hahahah
its not overwhelmingly perfect. A little sanding would make it so .
Re: circle cutting jig for table saw
Perhaps you could use them in making some phil thein baffles.
Re: circle cutting jig for table saw
yup yup i did plan to use it for that to 🙂
Re: circle cutting jig for table saw
I got two circles where i dont know what to do with them hahahah
its not overwhelmingly perfect. A little sanding would make it so .
see seumas2 channels in youtube open the video cutting a perfect circle, macduff even impressed himsel', slainte mhath macduff
Re: circle cutting jig for table saw
"see seumas2 channels in youtube open the video cutting a perfect circle, macduff even impressed himsel', slainte mhath macduff "
:confused::confused::confused:
The devil will find work for idle hands to do.-Morrissey