I disassembled our automatic washing machine to clean it of soap residue that clogged the drain system. As you can see it is very dirty already. There is an outer tub and an inner tub.
I need to remove the inner tub to access the dirty nooks. I only managed to remove the spanner bolt after days of putting WD40.
But still I cannot pull out the inner tub from the tranny shaft which is at the bottom.
I tried some force using a hammer but it wont budge. I put hot water hoping it will dissolve the soap but no success. I even improvised a puller system using some wires and jack but the wire gave out. Any ideas and suggestions?
Sent from my GT-N5100 using Tapatalk 2
Re: Help! Removing washing machine tub.
wait ko rin reply ng mga masters dito, problema ko rin to e, hindi ko matanggal yung nasa gitna
yung sabon talaga yung cause ng dumi at nagpapabara pati sa drainage, thats why ngayon we dont use the commercial detergents sold in supermarket, yung liquid type na + konting vinegar, pag nagde-drain sya makikita mo yung mga buo buong sabon na natatanggal, hope after some time e mawala na lahat yung nasa loob na tumigas na..........
Re: Help! Removing washing machine tub.
Bro tingnan mo nga mabuti..baka may snap ring na lock sa spindle ng motor kaya ayaw matangal..
Sent from my iPad using Tapatalk
Re: Help! Removing washing machine tub.
Sa agitator, may tinatangal doon na bolt, covered ito ng plastic cap? Post ka ng picture ng loob ng tub para step by step natin ang procedure.
Re: Help! Removing washing machine tub.
Sa agitator, may tinatangal doon na bolt, covered ito ng plastic cap. Post ka ng picture ng loob ng tub para step by step natin ang procedure.
