Forum

Share:
Notifications
Clear all

how tough is 2 part epoxy paint on alum?

4 Posts
3 Users
0 Reactions
66 Views
(@spyghost)
Posts: 321
Reputable Member
Topic starter
 

something to the lines of

http://www.daviespaints.com.ph/mobile/primers.htm#epoxyp

http://www.daviespaints.com.ph/mobile/metal.htm#epoxyenamel

I'm planning on using this to refinish a mountain bike...

 
Posted : 25/04/2015 2:48 pm
(@boo-semi-retired)
Posts: 551
Honorable Member
 

@ spyghost, i'm also interested about how good is this 2-part epoxy paint as i will have a lot of GI pipe railings that i need to install at the roof deck. i checked the URL you posted and one thing i noted is about the application method by spray ... in most website i visited about paints, almost all of them just mentions "spray" without elaborating whether you can use a normal air compressor for spraying or you need to use the more expensive and hard to find, airless spray system ... since this is an enamel based paint, i assume that you can use a normal air compressor for spraying it. is this a correct assumption? ... cheers

Boo!

 
Posted : 26/04/2015 4:26 am
(@teardroprock)
Posts: 16
Active Member
 

i had my luck spraying with a normal compressor. the bike sissy bar that i sprayed on was rusty. now, to combat that rust, i did used cup brass brush with angle grinder. after that, i just applied a rust converter. after that, i sprayed the color epoxy. i didn't use an epoxy primer. the paint still holds today

 
Posted : 04/04/2016 3:20 am
(@boo-semi-retired)
Posts: 551
Honorable Member
 

thanks for the info ... cheers

Boo!

 
Posted : 04/04/2016 4:55 am
Share: