Forum

Share:
Notifications
Clear all

carbon graphite rod needed

4 Posts
3 Users
0 Reactions
62 Views
(@redfurry)
Posts: 76
Trusted Member
Topic starter
 

as stated...no matter how long ...diameter size would be 6mm (round)....hollow or solid...

regards,

ron

 
Posted : 16/05/2012 1:05 pm
(@balarila)
Posts: 1368
Noble Member
 

Re: carbon graphite rod needed

Sorry, I don't have an answer. Just curious what you will use it for.

I'm aware (but not completely familiar) of carbon graphite's structural properties. It may be useful for some of our projects here.

 
Posted : 16/05/2012 5:59 pm
 guad
(@guad)
Posts: 646
Honorable Member
 

Re: carbon graphite rod needed

seen at the hobby store mentioned in the below thread

strips ... rods up to 5 mm only ... tube 6 x 1000 mm P260 ... last i checked

anyone know of other local sources?

Doweling

 
Posted : 17/05/2012 12:29 am
(@redfurry)
Posts: 76
Trusted Member
Topic starter
 

Re: carbon graphite rod needed

Sorry, I don't have an answer. Just curious what you will use it for.

I'm aware (but not completely familiar) of carbon graphite's structural properties. It may be useful for some of our projects here.

hi balarila....

i currently in need of it because we are coring our shafts with these cg rods...about 6 inches up to 20 inches go inside the maple shafts and they do make the shaft hit like a tank...errr harder hitting shaft....

thanks and regards
ron

 
Posted : 17/05/2012 1:45 pm
Share: