i'm tired of moving my bench grinder stand everytime i clean my work space..so i decided to build a new one that i can attached it in the wall..
choice of material...5mm sheet plate..para maiba naman.
[IMG]
[/IMG]
measuring and marking..the top base will be 14''x7/1/4''
[IMG]
[/IMG]
cutting sheet plate using angle grinder..
[IMG]
[/IMG]
[IMG]
[/IMG]
Re: bench grinder mount
be sure to wear safety gear such as face shield/goggles and gloves..cutting metals using angle grinder always pose danger to operator..
[IMG]
[/IMG]
[IMG]
[/IMG]
then grinding sharp edges..
[IMG]
[/IMG]
[IMG]
[/IMG]
Re: bench grinder mount
if you will notice i drill each corner..this will prevent me from over cutting the corners.
[IMG]
[/IMG]
after done cutting..
[IMG]
[/IMG]
and now for bending the plate..5mm is thick and i cannot manually bend it with my bare hands..what i do is sinugatan ko lang ng konti yung plate ng angle grinder using thin cutting disk mga half way lang siguro bago maputol yung plate.
[IMG]
[/IMG]
[IMG]
[/IMG]
Re: bench grinder mount
2 down 2 to go..
[IMG]
[/IMG]
[IMG]
[/IMG]
checking if the bend is 90 degree angle..
[IMG]
[/IMG]
this will be the base of bench grinder..
[IMG]
[/IMG]
Re: bench grinder mount
then full weld each corner..
[IMG]
[/IMG]
my favorite part...burning metal!
[IMG]
[/IMG]
[IMG]
[/IMG]
other side of the plate welded
[IMG]
[/IMG]
Re: bench grinder mount
no weaving whatsoever..just run and burn..
[IMG]
[/IMG]
rear side of the plate..
[IMG]
[/IMG]
[IMG]
[/IMG]
and front..
[IMG]
[/IMG]
Re: bench grinder mount
[IMG]
[/IMG]
fully welded plate..
[IMG]
[/IMG]
after grinding and cleaning the welds..
[IMG]
[/IMG]
then drilled..
[IMG]
[/IMG]
Re: bench grinder mount
this is where i attached the grinder mount..sa poste para mas matibay ang pagbaon ng dyna bolt.
[IMG]
[/IMG]
[IMG]
[/IMG]
dry fitting ...not done yet i'm just orienting myself if the height fits to me..
[IMG]
[/IMG]
and now for the second phase..need to cut and bend this to reinforce the base..
[IMG]
[/IMG]
Re: bench grinder mount
[IMG]
[/IMG]
[IMG]
[/IMG]
trimming the edges..
[IMG]
[/IMG]
applying galva coat primer..
[IMG]
[/IMG]
Re: bench grinder mount
here's the finished product..
[IMG]
[/IMG]
double nut..para hindi lumuwag dahil sa vibrations..
[IMG]
[/IMG]
[IMG]
[/IMG]
much neater than my previous bench grinder stand..
[IMG]
[/IMG]
Re: bench grinder mount
that's all folks and thanks for watching...:p
Re: bench grinder mount
Nice! You have a sense of orderliness in your workshop.
My circumstances are different from yours, but i have issues with rust and tools "disappearing" on a rather open space area.
Re: bench grinder mount
thanks bro owyn...sakin sa hiraman nawawala:p
