lazy sunday = rip sled for TS

Tools

Last Post by beebeenator 15 years ago

4 Posts

2 Users

0 Reactions

53 Views

RSS

beebeenator

(@beebeenator)

Posts: 1468

Noble Member

Topic starter

runner and a 'border' to make sure it runs straight. The border 'hugs' the edge of the table top

Hold downs.. supposed to have toggle clamps at the end, but found out i didnt need the toggle clamps

slots on the sled. i dont really know the advantage of having slots on both the hold downs and the sled itself. but i didnt see any drawbacks so i went with it anyway

Posted : 14/02/2010 6:49 pm

beebeenator

(@beebeenator)

Posts: 1468

Noble Member

Topic starter

Re: lazy sunday = rip sled for TS

lazy person's knob

wow! it works!

it works too! The hold down pressure seems ok but the phenolic is really slick. So i may put a sheet of sand paper on the sled and underneath the hold downs

Posted : 14/02/2010 6:55 pm

bbn

(@bbn)

Posts: 904

Prominent Member

Re: lazy sunday = rip sled for TS

Nice work Bee. Since you have a nice cement floor for your workshop, an infeed/outfeed tables or roller stands would be helpful. Just make sure the table saw is firmly planted.

Posted : 14/02/2010 8:53 pm

beebeenator

(@beebeenator)

Posts: 1468

Noble Member

Topic starter

Re: lazy sunday = rip sled for TS

Thanks Incc. I have plans for an infeed and outfeed extension once i have finalized where to permanently position the saw.

Also plan to put a drawers and cabinets for it

Posted : 14/02/2010 10:21 pm