Forum

Tools and ABS/Plexi...
 
Share:
Notifications
Clear all

Tools and ABS/Plexi/etc.

5 Posts
2 Users
0 Reactions
47 Views
B2Bomber
(@b2bomber)
Posts: 149
Estimable Member
Topic starter
 

I've got several questions in mind regarding tools (different ones) to use with ABS Plastic/Plexiglass/Acrylic. First off --

what type of router bit should I use in working with this material?

TIA

Safety first - always wear face/eye/ear/hand protection as a minimum.

 
Posted : 05/08/2008 6:38 pm
bbn
 bbn
(@bbn)
Posts: 904
Prominent Member
 

Re: Tools and ABS/Plexi/etc.

I've used carbide bits with plexiglass, acetal and PVC.

 
Posted : 06/08/2008 7:05 am
B2Bomber
(@b2bomber)
Posts: 149
Estimable Member
Topic starter
 

Re: Tools and ABS/Plexi/etc.

ok thanks.

apart from a jig-saw what could a DIYer use to cut designs within an acrylic sheet? TIA

Safety first - always wear face/eye/ear/hand protection as a minimum.

 
Posted : 06/08/2008 4:46 pm
bbn
 bbn
(@bbn)
Posts: 904
Prominent Member
 

Re: Tools and ABS/Plexi/etc.

Assuming you use a jigsaw because there lots of curves, a small bandsaw or a scroll saw are alternatives. If you just want to cut straight any fine tooth saw should do.

 
Posted : 07/08/2008 1:39 pm
B2Bomber
(@b2bomber)
Posts: 149
Estimable Member
Topic starter
 

Re: Tools and ABS/Plexi/etc.

yup, I'm looking at plenty of curves, say like logos, or letters, etc. hmm, I don't think these bandsaws/scrollsaws are feasible at the moment... 🙁
anyway, thanks for the reply again.

Safety first - always wear face/eye/ear/hand protection as a minimum.

 
Posted : 09/08/2008 4:07 pm
Share: