Topic starter
Planning to perform a top overhaul on my inlaws Honda wave 100 (replace valves, seals, springs, maybe upgrade to a stage 1 cam, etc). Tried googling it to no avail. Anyone here know how much lb-ft i should set my torque wrench at during re-assembly? Its an all aluminum engine (i think) and i'm concerned I may over-tighten and strip something.
TIA! :thanks:
Posted : 24/07/2015 4:36 am
I hope this helps.
http://www.motorcyclephilippines.com/forums/showthread.php?242356-engine-bolt-torque
Posted : 24/07/2015 10:11 am
Topic starter
Thanks for the assist sir! I actually spent a whole 9 hour shift googling to no avail ( it was a slow day, don't judge, 😀 ). Just goes to show how inept I am sometimes with technology. 🙂
Posted : 28/07/2015 4:56 am