Here you go Jonathan, fill up the details na lang...
click my signature and it will take you there........
Re: Jonathancruz WW contest entry
hay salamat,you truly are very patient enough,hehehe,sige i'll put on the details later as i go on with the project,busy pa sa work,thanks very much.
Re: Jonathancruz WW contest entry
this is my cutting diagram
Re: Jonathancruz WW contest entry
jonathan, reduce the picture sizes pls to 480x640 pixels. hindi kasi namin makita yung complete pictures eh.
click my signature and it will take you there........
Re: Jonathancruz WW contest entry
reminder lang Bro. dapat 2pcs ng 3"x 1"x 24" ha...not more ha.... pakibawasan na lang ng konti para saktong 3" wide... 🙂
click my signature and it will take you there........
Re: Jonathancruz WW contest entry
sorry sir i thought i have already resized my picture,about the wood size,i actually cut the blanks from the 1x8 blanks to get the exact 2pcs of 1x3x24 piece(daya no),pero ok lang kung bawasan kopa ng konti.thanks bro.
Re: Jonathancruz WW contest entry
looking good, I can't even make out what you are going to do, but it seems nice and going to be useful.
click my signature and it will take you there........
Re: Jonathancruz WW contest entry
hehehe,maski ako hindi ko mafigure out what's my contest piece,hehehe,saturday ko pa ma-start.wish me luck.it's getting late,may work pa bukas.later on i'll be asking ulit another favor sa'yo sir sonny,to create me again a new thread(been building a workbench)actually i'm almost halfway there.matatapos na lower portion,it means table top na susunod(which i think is the hardest part of building the wb.)thanks,wala talaga ako masabi sa linaw ng mata mo bro,you truly are perfect craftsman.goodnight,mabuhay sa PHM!
Re: Jonathancruz WW contest entry
cutting tha pieces to it's sizes(note...the saw blade stop for viewing purpose)[IMG] http://i1212.photobucket.com/albums/cc448/jonathanscruz6 8/DSCN6729.jpg[/IMG[IMG]]
Re: Jonathancruz WW contest entry
sanded
Re: Jonathancruz WW contest entry
glue pieces A & B
Re: Jonathancruz WW contest entry
rounded the top left & bottom right of left piece c & top right & bottom left of right piece c with a 1/4 half round router bit.and put a 1/8 deep 1" long rabbet at the bottom of pieces c
Re: Jonathancruz WW contest entry
rabbeting the edges of piece d leaving a 1/4 thick tongue & routing a 1/4 thick & 1/8 deep groove to piece e for the mating surface of piece d
Re: Jonathancruz WW contest entry
then rout a 1/8 thick 1/4 wide tongue to side of pieces e
Re: Jonathancruz WW contest entry
dry fitting pieces d & e