here is my quickie project, almost complete after three days of work...
click my signature and it will take you there........
Re: low center table build...
still in the dry-fitting stage, no finishing yet on the leg assembly. top and shelf still in sanding sealer stage.
click my signature and it will take you there........
Re: low center table build...
those are nice looking solid slabs
what wood are those?
Re: low center table build...
those are nice looking solid slabs
what wood are those?
those are Pine from your friendly wood store... "W" where you buy your wood too...
click my signature and it will take you there........
Re: low center table build...
I still am wide awake, hmmm, lets start the finishing... will need about 4 to five coats anyway....
using hardwood oil, my first coat is applied...
immediately the tenons built definition and character...
after 10 minutes I wipe it off, ganun talaga parang golf, pinapalo tapos hahabulin...
after 5 minutes, the second coat is applied...
click my signature and it will take you there........
Re: low center table build...
not much of a photobug(I guess that is obvious), but here are some more shots after the second coat is applied... (with flash)
and comparing with and without finish...
without...
with...
click my signature and it will take you there........
Re: low center table build...
wow nice build timb!
your tenons are a bit proud...hmmm...greene and greene design ha!
lucky you youve got that large slab of pine with beautiful grains.
what wood oil did you use btw?
its also nice to buy at "W" coz most of their stocks were preselected.
cheers!
The devil will find work for idle hands to do.-Morrissey
Re: low center table build...
the legs are goncalo but how about the stretchers?
The devil will find work for idle hands to do.-Morrissey
Re: low center table build...
tanguile... for the stretchers... but very dense as well. I used my favorite hardwood oil "Sandolin" thanks Doc, you can call me Sonny here...
click my signature and it will take you there........
Re: low center table build...
That's a nice table. The goncalo really stands out. How do you plan on attaching the table top and shelves?
Re: low center table build...
big hole at the bottom part of the stretchers
small exit hole...
still undecided how to address wood movement though....
click my signature and it will take you there........
Re: low center table build...
into the last leg of the build...
I smoothen the edges sanded the sealer and applied two coats of Tung oil...
all I do now is watch it dry... 😛 two more coat goes in later though 😉
click my signature and it will take you there........
Re: low center table build...
final pictures before leaving for its permanent residence...
last minute completion and touch ups...
click my signature and it will take you there........
Re: low center table build...
That looks real nice!
Re: low center table build...
the completed table with the gears, picture taken by the owner...
click my signature and it will take you there........