no nonsense quick squaring router fence tip

Woodworking Forum

Last Post by violaine 14 years ago

5 Posts

1 Users

0 Reactions

32 Views

RSS

violaine

(@violaine)

Posts: 1926

Noble Member

Topic starter

i bought these keychain type steeltape from handyman and a steal at 50% off...

the width of the tape is about 1/4"
what i liked about this tape is its flat unlike its bigger siblings that are convex. this will serve some purpose to my router table.

The devil will find work for idle hands to do.-Morrissey

Posted : 25/07/2010 3:28 pm

violaine

(@violaine)

Posts: 1926

Noble Member

Topic starter

Re: no nonsense quick squaring router fence tip

even though i have these wonderful fence clamps allowing me to set my router fence quickly, i was still looking for other ways how to quickly position the fence on both ends of the plate.sometimes its a time consuming thing.

with the gmr1 armed with a 1/4" straight bit (i would have wanted the four flute spiral bit but it was too long the overhang is greater than 1/8") i routed the recess for the steel tape (a tenth of a millimeter perhaps) on the phenolic plate.