Here's some pics of a just finished project. A small altar table which fits in a niche hence the small size.
Basically made of plywood with hardwood edges.
Using a shopbuilt straight edge, cutting sheets of plywood is manageable with good results.
Plywood cut to size. Using a straightedge also helps prevent tearout in plywood when cutting crosscut
Assembly of the table. Since the project called for something close to 50mm thickness i used 3 layers of 3/4" ply sandwiched together. I just used strips of 3/4 ply in the middle as a whole piece would have been wastefull.
Re: small altar table
With edging routed flush using a trim router
Since this was to be painted semi-duco, masilya was needed to have a smooth finish. Making my own masilya made sanding a lot easier.
Painted enamel using a roller. I don't normally use enamel because of its long drying times but had no choice.
Re: small altar table
very nice partner, seems like a weekend project. keep em coming...
sent you pm...
click my signature and it will take you there........
Re: small altar table
No action yet on the Leigh Jig Moji?
Violaine is in too but where is Owyn?
Millermatic 180 Autoset Mig Welder
Miller Spoolmate 100 Spool Gun
Victor Firepower 350 Oxy Ace Outfit
3M Speedglas 9002X AD Helmet
Makita LC1230 Dry Cut Saw
Ingersoll Rand Air Tools
Snap On Tools
Metabo Power Tools
Norseman Drill Cutting Tools
Bosch Power Tools
3M PPS
Re: small altar table
No action yet on the Leigh Jig Moji?
Violaine is in too but where is Owyn?
Owyn hasn't logged in the other site since Feb 22, 2010... baka ikakasal na 🙂
click my signature and it will take you there........
Re: small altar table
did I see you using stikwell Moji??? those hardwood edges must be nailed if you are using that glue, tama ba?
click my signature and it will take you there........
Re: small altar table
those hardwood edges must be nailed if you are using that glue, tama ba?
Seriously?? i only glued the hardwood edges... i ran out of elmer's wood glue eh..
No action yet on the Leigh Jig Moji?
I gave it a run already, i made a test box..But i made box joints not dovetails though..hehe
Re: small altar table
the reason I asked if they were nailed is because when I used stikwell, it never seemed to dry completely... must be a bad batch I got before...
click my signature and it will take you there........
Re: small altar table
Oh i see..must have been a bad batch, the stickwell dried up pretty good on this one.
Re: small altar table
Ganda Nito ah.. ahaha 😉 Idol si moji
Re: small altar table
Ganda Nito ah.. ahaha 😉 Idol si moji
wala pa yan, you should see his other works... 🙂 and welcome drillchuck to pinoyhandyman...
click my signature and it will take you there........
Re: small altar table
Hello,
I am looking for other altar designs on the web, yong simple lang at naka dikit sa wall, small designs lang pero ala ako mahanap. Any other site kung saan ako makakahanap ng mga altar designs/wood plans?
Phils. Exam Resuts - www.examresultsph.com
