Forum

22y
22y
@22y
Trusted Member
Joined: Jan 6, 2008
Topics: 1 / Replies: 53
Reply
Re: Automated Programmable Exhaust Fan

Re: Automated Programmable Exhaust Fan My brother has one of these, works a treat, that will cover the programmable and timed plus you can even ...

11 years ago
Reply
Re: jet pump alternative

Re: jet pump alternative Hi This is a good project hope this helps, I think you need the following; 24hr timer (wall plug type) Float switc...

11 years ago
Reply
Re: Wood type for Doors

Re: Wood type for Doors I'd go for option B. 400 php difference on the door and 700 php on the frame is well worth it. Not sure what "Regular W...

12 years ago
Reply
Re: Cutting Aluminum Composite

Re: Cutting Aluminum Composite Sorry, that reply was incomplete was also wrenching my hobby, anyway there are a few issues when using a track gui...

12 years ago
Reply
Re: Cutting Aluminum Composite

Re: Cutting Aluminum Composite Naku malabo yata. Kasi ang action ng Jig saw is similar sa lagereng bakal (Hack Saw) or Band Saw. magkakaroon ng t...

12 years ago
Reply
Re: Cutting Aluminum Composite

Re: Cutting Aluminum Composite Hi None ferrous saw blade triple chip grind. Yung tip alternate trapezoid and flat. The thicker the better ag...

12 years ago
Reply
Re: Bosch GSR 9.6 Dead Battery

Re: Bosch GSR 9.6 Dead Battery Hi Tris, Info on lipo; a fully charged 11.1V will have a voltage of 12.6V. Your, 1100mah 20c will give a max amp...

12 years ago
Forum
Reply
Re: Old School Spraygun

Re: Old School Spraygun From my experience, 2 stage ang trigger. If you pull it around 10 percent ng travel pattern air lang lalabas pull it more...

12 years ago
Reply
Re: pvc edge banding

Re: pvc edge banding Hi Rhey, depending on the type of pvc you get (preglued or bare) you either iron it on (I prefer a heat gun with a rubber ro...

12 years ago
Reply
Re: Problem with plywood (uneven surface)

Re: Problem with plywood (uneven surface) Hi, Solusyon po namin sa blister after may finish na ay lagyan ng masking tape at sugatan sa gitna...

12 years ago
Reply
Re: wood adhesive

Re: wood adhesive Mga sirs check nyo this company baka makabili kayo sa suppliers nila ng bultuhan . Nasa Las Pinas sila. Posted via PHM Mobile

13 years ago
Reply
Re: plywood cabinet

Re: plywood cabinet My 2c lang po, Try nyo Block Board, I know medyo mahina kasi Falcata ang core pero mura and if properly painted will last you...

13 years ago
Reply
Re: toggle switch

Re: toggle switch You may have a problem with holding torque specially on the spool i would suggest a 360deg servo to hold your positions. Just m...

13 years ago
Reply
Re: all about tablesaws

Re: all about tablesaws No need to be afraid of fingers lost, sawstop.com

14 years ago
Reply
Re: Spiral upcut/downcut router bits

Re: Spiral upcut/downcut router bits Hi, Spiral downcut bits are best used on trenching formica or melamine faced boards, the downward slici...

14 years ago
Page 2 / 4