Re: DIY Bandsaw Pictures or never happened!!! 😀 just a teaser..:p Makita green (Made-in-China)
Re: DIY Bandsaw I will but where is this section? I noticed that you dont have any tracking correction system, are you going to use your upper ...
Re: Happy Father's day (2013) Happy Father's Day to us all here.. Cguro ako magpa -facial muna :p then manicure and pedicure..:D
Re: DIY Bandsaw Did you try to cut without the guides? Have you tensioned the blade? no of course, i want to use this machine with still c...
Re: DIY Bandsaw Here is the video that I took lastnight of my band saw already running with the blade. A little bit noisy due to the slack v-bel...
Re: DIY Bandsaw backside pictures: . it looks very close na to my design. . I was able to made it run and took a video ...
Re: DIY Bandsaw Seized the holiday very early and went straight to Tony's for my compression springs. Sir @willyfernando was right they have plen...
Re: DIY Bandsaw very nice idea Sir on multiple pulley, Thank you so much, :thanks: level up bandsawing na ito with blade cooler pa.. can't wait t...
Re: DIY Bandsaw ...By the way, have you considered incorporating a speed reducer for your motor like a worm gear reducer or frequency inverter? I...
Re: DIY Bandsaw Sudden trip to Batangas left me only a few hours of works for my band saw. Managed to finish only the wheels. . here the t...
Re: DIY Bandsaw Compression springs from salvaged machineries are available at Tony's Junk shop near at the corner of J. Molina Ave. and E. Rodri...
Re: DIY Bandsaw Joey's concern is really valid and i have a couple of ideas to address it. 1. Compression springs above the shaft block ...
Re: DIY Bandsaw good catch joey, actually wrong angle ang nangyari and then the flat bar that i got was way too wide from the original plan. ...
Re: DIY Bandsaw I continued working last night on the shaft block. here I inserted the nut on top of the block, this will be the same on ...
Re: DIY Bandsaw I think it would be better if I email it to you so you can play around with it and take all the measurements, I saw your sketchup...
