Re: LNCC63's workshop @Jay Thanks for the insight bro. Never thought about it that way: air tools afford greater control due to their ligh...
Re: Craftsman Dovetail Jigs This is great Bee! I've had that thing for so long it is good to see it being put to good use. Could please pos...
Re: Plywood Choices... The Tuff brand of plywood, made by EMCO, does not have a pretty veneer but I'm very very sure it is THE best plywood in t...
6" velcro sanding disks I don't think these are a bargain but since in my experience they are difficult to fine I'll post them:
Re: LNCC63's workshop The pictures are for Bee who is building his router table. Please take note, I do NOT like this fence because it is flimsy...
Re: LNCC63's workshop Here is the equalized photo the inside:
Re: LNCC63's workshop I bought this thing for P3k I think. It was in a lot better condition then, now I'd probably not pay that much. The reaso...
Re: LNCC63's workshop Thanks for sharing about air driven grinding tools. I saw one at MyTools and they aren't too expensive it seems. Since th...
Re: LNCC63's workshop Quick! Go the trash can and get those brushes you threw out ... not for using with a grinder but with a drill press or your...
Re: LNCC63's workshop My new Record vise mounted. Really happy with it. Thanks guys for posting it and for Bee for swapping me for it. ...
Re: Suggest me a 7-1/4 circular saw I think I've noticed the store. Never went there though because of the accessibility. Good to know just th...
Re: Suggest me a 7-1/4 circular saw ... rollins mercantile cubao, along edsa, near victory liner station. mura mga makita and maktec tools dun ...
Re: is there a shop that pre-cuts purchased stock? A friend of mine had a sash factory along the Manila East Rd. do it. There are several in th...
Re: Suggest me a 7-1/4 circular saw i drool when i see one 😛 btt: do you have any models in mind? That's what I meant ... I see the...
Re: may i have a peak at your router table fence? Make templates for the hole in the bottom and the side then use a router trimming bit. Use a h...
