hi! newbie here from Rizal. maki ride na rin po ako sa thread na to. im looking for a table saw, i've narrowed my choices to Bosch GTS10j and Jet JTS1...
Same thoughts as rosy. You can't go wrong with Vespa. Powermax is new to me, too.
I don't own a 10J. I just know of others who have made the modifications. You can read about it here:
Out of the box, no. You can have the inner flange machined to remove the raised middle part. This will allow you to use blades with 5/8" arbor. Dad...
I agree with rosy. They probably didn't improve the design, only specified a lower duty cycle to address the high occurrence of breakdowns. Plus cos...
I also outsourced the aluminum welding to a friend in Laguna.
Addtional support... I can't say. Mine is supported because I also installed a router table on right side. Yes, you can use the included fence. ...
If you are limited by the 10J's rip capacity then I can offer you a solution. I have the US version of the GTS10J, the GTS1031. I was able to in...
If I may quote another DIYer: "The bitterness of poor quality lingers long after the sweetness of cheap price has faded." This one is mine: "...
It depends... on how much load is going to be carried by the screw... which is highly dependent on your design. We can help you better if you pos...
I agree with rosy. When I read "2 storey", getting the help of a certified structural engineer immediately came into my mind.
You can try San Jose
Anchor it to the concrete. Use longer screws plus tox.
