Recently I removed the the 2-inch concrete topping of a 20 sqm room using an Ozito demolition hammer. I borrowed it from a friend who bought it sever...
Thanks sa info. Kung maingay pa ang TS eh di ok pala to. Pwde naman ilagay sa malayo compare sa TS na nasa harapan mo always. I'm the previous ow...
The Bosch GTS10J is also available locally. Last time I heard the price is 33K, with gravity-rise stand. And BTW, the reason why there is no thr...
Almost there! Some more slick tape Cut a channel on the underside for the vise screw Gluing the cover for the screw side
Some slick tape to reduce friction Gluing the runner to the wagon housing. With the wagon in place to keep the runner in position, a c...
Almost forgot about the dogholes One technique for cutting dadoes without measuring. First pass using the a spacer that matches the width of ...
Finally! Time to glue with the other half of the wagon Just for kicks. Looking good!
Not bad But worse. The vise screw is way off-center Perfect job for Ursula's cousin
Now for the wagon. The screw is just a bit smaller than 1 inch Drilling on the end grain. Workpiece must be securely clamped My fors...
Got the chance to work on this project today. These 2 pieces will house the tail vise Drilled the series of dog holes along one piece. 3...
Try starting with a harder type of steel. Like tool steel.
Time to assemble the legs Forgot to take pictures of the final assembly of the legs and stretchers. I now have a decent storage for wood scra...
I didn't remove the waste all in one go because I needed it for the router's base to sit on. Some of the cuts in the miter saw went too deep ...
Cut the mortise for the bottom stretchers Then the lap joint for the upper stretcher
First pass, with the bearing riding along the lip of the mortise After routing full-depth and cleaning out the corners One down, 7 mor...
