@ Armand medyo malambot pa nga ang 2 inches thick na MDF... kaya ginawa ko nilagyan ko ng 1.5 x 1.5 inch na angle bar support sa likod... pagkalagay...
test fit of motor mounting... i will be using a water pump motor... but the problem is it is turning in the wrong direction. so i will be mouting it o...
half of the hole routed on the MDF clamp clamp clamps... 4 pieces 1/2inch MDF
update... rough cut on the 1/2 inch MDF routed for final shape of mdf routed 1/2 holes for the mounting of wheels
Same here... Can not view visitors message
bandsaw specs will be... 14 inch capacity any inputs in the build will be highly appreciated... specially those who has an orginal bandsaws at th...
cut out 4pieces 1/2 inch mdf for the body of the bandsaw.. it will glued all together.
finished wheels use a router to create the grove on the center then spray with sanding sealer.
cut out the wheels using Maktec router trimmer MT370 form MDF
wheels bearing attachment wheels with bearing
Hi lambert can post photos of the plywood?
Wow goodluck... Keep posting photos
Hi armand, i am planning to build a homemade bandsaw... Kung ok lang pwede ko ba mahingi ang dimension ng bandsaw mo? Yung diameter ng wheel tsaka hei...
