Re: Automotive Tools I use a 6 amp too. But on big items like lathe rails, i found i had to use a pc PSU in conjunction with it to give the bubbl...
Re: Craftsman Jointer Rehab. Thanks for the vote of confidence but i really just learn as i go. Had i digested fully the blow up diagram in the m...
Re: midnight club... I'm sorry to hear about that timb, am aware poly's one of the toughest finishes out there, and it being a conference table, ...
Re: Manual Screw Drivers Hi JayL =). I wonder how Rubicon stacks up to the well regarded Wihas. In my limited experience I think they're go...
Re: midnight club... I've been enjoying the eiga sai (japanese film fest) at shangrila (free screenings, will run till next weekend.) For anyone ...
Re: midnight club... No work in the shop while the shop's getting worked on. Too dusty, noisy but it should be done by next week. Another 1.2m wi...
Re: pls post pics of storage solution in your workshop lumber rack ^_^. Made a rafter to the insulated ceiling. It won't get rained or be under t...
Re: My Commissioned Conference Table build... Those sure look rough and needs to be milled sir Timb. So now you have some means to tune the makit...
Re: midnight club... Logging out. Gosh, i'll be a walking zombie for tomorrow's work. Pics when done =).
Re: Online seller on Sulit ^mechanic's or WW vises? I've read a few cases in sawmillcreek who's QR's are a bit dodgy so that put me off. The unco...
Re: midnight club... If you havent' come across this, here's a guidline for DPs for metalworking sir JayL. .004" = .01mm I dunno why b...