also take the time to think about the ref, oven, fume hood so the builders will harmonize them in the project...they come in different shapes and size...
hey bro! you mentioned about finger jointed wood...this is even better because it is still solid wood and not plywood...they are glued anyway. ...
they say that when you are getting old, you tend to think about the earth and the things around it. does that mean, i am already old too? hehe ...
Subscribed!!!
it wont hold if you just use the F30 brad nails..its ok to use brad nails if its 16G and about 1 1/2" long...screws are better but needed a pilot hole...
but i still measure and cut these plywoods in the conventional units.
our plywood now is stamped at the end with metric units...and are even undersized!
hmmmm i never thought this cheap pad paper can be used as templates for this and that. cool tip bro!
it would be an overkill if i use a drill to drive these 3/4" long screws. I still miss manual handwork btw and this is one of them. But repetitive inj...
i will be using a 3/4" gypsum screws and so i adjusted the countersinks. Chuck the bit to my trusty dill And drill away! Before putting...
Boo, that info is fantastic! except that the total cost which is 1.2K is unimaginable considering the cost of materials nowadays. so if its dirt cheap...
Stanley Try squares arent square anymore, their hand planes now sport cheap plastic knobs and blade adjusters which are of poor taste and flimsy and e...
if money is easy..id go for hardwoods for beauty..i cannot skimp on the eaves and i thank God the metal spandrels were invented....hardiflex is not fo...
Salamat sa TIP boss where is the tip????
