Forum

Sir are you using Sketch Up for your 3D rendering?

Planning on building this TIG cart for my new welder... Any suggestions is appreciated... Sir are you using Skecth Up for your 3D render...

yes you can! but it is not ok for me...the square drive screws has about 12mm of unthreaded length and this is the trick to pull the two woods to...

Check this website: . They have the complete lines of furniture hardwares and their store is located in T. Alonzo, Manila Good morning Sir...

we may have made pocket hole jigs in the past using wood and two step drilling but we found out that the wooden jig may not last long and cumbersome t...

Kreg is available from JayL: Thanks